Powder Room Remodeling Scottsdale AZ turns the smallest room in your home into the one guests remember. Whether you need a powder room renovation in Scottsdale or a quick small powder room makeover Scottsdale, we handle tile, vanities, lighting, and plumbing from start to finish. Most powder rooms are finished in 5 to 10 working days, and we keep the dust contained so the rest of your house stays livable.
Powder Room Remodeling Scottsdale AZ is the trade of rebuilding a half bath, the toilet-and-sink room with no tub or shower, into a space that looks intentional instead of forgotten. We pull the old vanity, reset the toilet flange, patch and waterproof the walls, then set new porcelain tile, a quartz countertop, and a vanity cabinet that actually fits the footprint. Because there is no shower pan or tub surround, the scope stays tight and the mess stays small.
Most Scottsdale homeowners call us because the powder room is the first thing guests see and the last room anyone updated. Hard water stains etch the faucet, the exhaust fan has quit moving air, and the vanity cabinet is warping from a slow sink leak. If you have been searching for a powder room contractor in Scottsdale, Arizona, we can walk the room, measure it, and give you a straight number the same week. We also handle powder room renovation near me Scottsdale calls for rental properties and short-term rentals that need a fast turnaround between guests.
Every powder room remodel we quote covers the full rebuild of the room, not just the pretty parts. Below is what is standard. Moving the toilet drain, custom cabinetry, and structural changes get priced separately so you can see exactly what you are paying for.
We remove the old toilet, vanity, flooring, and wall tile, then haul everything away. Floors and the hallway get protected with rosin paper and zip walls, and we run a HEPA vacuum on the demo saw to keep dust out of your living space.
We check the subfloor with a moisture meter, replace any soft OSB, hang cement backer board, and roll on a waterproofing membrane at the wet walls and around the toilet flange. This is the step that prevents mold and rot down the road.
You get new porcelain or ceramic tile flooring, a vanity cabinet sized to the room, and a quartz or granite countertop cut for your sink. We set tile to ANSI A118 standards and use epoxy grout in splash zones for durability.
We install the sink, faucet, and toilet, replace the wax ring and any corroded PEX or copper supply lines, and test every joint. A licensed plumber handles the rough-in so the work is code-correct and warrantied.
We install a GFCI outlet, new LED lighting, and a working exhaust fan ducted to the exterior. The room gets patched, textured, and painted with moisture-resistant paint, then we do a final walkthrough with you.
We come out, measure the room, check the toilet flange, test the exhaust fan, and look for moisture under the flooring. You get a written scope and a fixed price, usually within 48 hours. If a powder room renovation in Scottsdale only needs a vanity and paint, we will tell you that instead of selling a full gut.
We protect the hallway with plastic and floor protection, pull the toilet and vanity, and remove old tile with an oscillating multi-tool and a wet saw where needed. Any soft drywall comes out. If the PEX or copper piping is corroded, we replace that section now, before the walls close.
We hang cement backer board, roll on a waterproofing membrane, and set porcelain tile with a notched trowel and grout float. Grout lines get epoxy grout in wet-prone spots because it resists the hard water that Scottsdale taps are known for. A laser level keeps the first course dead straight.
We set the vanity cabinet, drill for the sink and faucet, connect the PEX supply lines, and caulk the backsplash with silicone caulk. The toilet goes back on a new wax ring and, if needed, a new flange. We install the mirror, LED lighting, and a GFCI outlet, then paint with moisture-resistant paint.
We run the faucet, flush the toilet three times, check every joint for weeping, and confirm the exhaust fan pulls air. You get a walkthrough, a maintenance sheet, and our warranty terms. If anything is off in the first 30 days, we come back and fix it, no argument.
We come out, measure the room, check the toilet flange, test the exhaust fan, and look for moisture under the flooring. You get a written scope and a fixed price, usually within 48 hours. If a powder room renovation in Scottsdale only needs a vanity and paint, we will tell you that instead of selling a full gut.
For clean cuts on porcelain and ceramic tile, especially around the toilet flange and door casing where a bad cut is obvious.
To spread thinset at the correct depth and pack grout into joints so tile bonds fully and the floor stays flat.
To check the subfloor and drywall for hidden water before we cover anything up. It catches slow leaks that the eye misses.
To set the first course of tile and the vanity perfectly level, which matters in a small room where a 1/8-inch error shows.
For precise cuts in drywall and trim during demo and around the toilet flange without tearing up adjacent material.
To seal the backsplash, sink, and toilet base with a flexible, water-resistant bead that will not crack like grout.
A pink-tile powder room near Old Town with a 21-inch-deep vanity that blocked the door, a running toilet, and soft subfloor from a slow leak. The exhaust fan had not worked in years and the galvanized supply lines were corroded.
After: We replaced the galvanized lines with PEX, cut out the soft subfloor, and installed 12x24 porcelain tile with epoxy grout. A shallow 18-inch vanity with a quartz top opened up the room, and a new ducted fan pulls air. Finished in 9 working days.
Book this service →
A 1990s powder room in 85258 with a warped oak vanity, stained laminate countertop, cracked ceramic floor tile, and a GFCI that tripped every time the hair dryer ran. The room smelled musty.
After: We installed a new vanity cabinet, a granite countertop, and porcelain floor tile, then replaced the GFCI and exhaust fan. The musty smell traced to a failed wax ring, which we replaced. The room was guest-ready in 6 working days.
Book this service →
A large powder room in a custom Paradise Valley home with dated brass fixtures, a cracked marble countertop, and lighting that made the room feel dim. The homeowners wanted it to match a recent kitchen remodel.
After: We set a Cambria countertop, installed a Kohler sink and Grohe faucet, added LED vanity lighting on a dimmer, and re-tiled the floor in natural stone. The room now reads as part of the same design language as the kitchen. Completed in 8 working days.
Book this service →Small rooms hide big problems. These are the calls we get most often from homeowners searching for powder room remodeling cost Scottsdale AZ answers.
Ask a pro →We pull the vanity, cut out any soft drywall or subfloor, fix the supply line or drain that is weeping, and install a new cabinet with a moisture-resistant back. We test the new connections under pressure before closing up.
We replace the faucet with a Moen, Delta, or Kohler model rated for the water here, strip the old caulk, and re-seal with silicone caulk. We also set a quartz or granite countertop that shrugs off mineral buildup.
We replace the fan, run new duct to the exterior, and confirm airflow with a tissue test. If the old duct was venting into the attic, we correct that, because it is a common and costly shortcut.
We pull the toilet, inspect the flange, and replace it if it is cracked. Then we set new porcelain tile over a flat, prepped subfloor and reset the toilet on a fresh wax ring.
Most powder room remodels in Scottsdale run $6,500 to $14,000 in 2026, with a cosmetic refresh at the low end and a full gut with new tile, vanity, lighting, and plumbing at the top. Cost moves with tile selection, vanity brand, and whether we find water damage under the floor. We give you a fixed price after a 30-minute walkthrough, so you are not guessing.
A standard powder room renovation in Scottsdale includes demo, new cement backer board and waterproofing, porcelain or ceramic tile flooring, a new vanity cabinet and countertop, sink and faucet installation, toilet reset with a new wax ring, GFCI outlet, exhaust fan replacement or repair, LED lighting, and moisture-resistant paint. Structural changes, moving the toilet drain, and custom cabinetry are quoted separately.
Plan on 5 to 10 working days for a typical powder room. Demo and rough-in take two days, tile and waterproofing take two to three, and fixtures, paint, and punch list fill the rest. If you order a custom vanity or natural stone countertop, add 2 to 3 weeks of lead time. We schedule the work so your house is not torn up for a month.
Cosmetic work like tile, paint, a new vanity, and fixture swaps usually does not need a permit. Moving plumbing, adding an outlet, or relocating the exhaust fan does, and the City of Scottsdale inspects that work. We pull the permit when it is required and meet the inspector on site so you are not chasing paperwork.
One walkthrough, one fixed price, no pressure. We are licensed, insured, and we warranty our workmanship for 2 years. Call now and we will schedule your estimate this week.
Get Free Estimate +18556124434 →Call +1 855-612-4434 or email [email protected] and we will get back to you the same business day. We answer the phone Monday through Friday, 8:00 to 18:00, and we schedule walkthroughs across Scottsdale and Maricopa County within a few days. Bring your wish list and your budget.