Old Fixture Removal
We shut off the angle stops, bleed pressure, and pull the old faucet, drain assembly, and supply lines. The deck gets scraped clean of old caulk and mineral buildup before anything new goes on.
Licensed, insured, and same-day ready across Maricopa County
Faucet Installation Scottsdale AZ Done Right the First Time
Faucet Installation Scottsdale AZ is what we do every day, from dripping kitchen fixtures to full bathroom faucet replacement in Scottsdale. If your faucet leaks, sticks, or dates back to the original build, we pull it, prep the surface, and set a new one that seals clean. We serve homeowners across 85251, 85258, and 85259.
Careful work. Honest options.
About this service
What Faucet Installation Scottsdale AZ Really Involves
Faucet Installation Scottsdale AZ is the removal of an existing fixture and the precise fitting of a new one, including supply line hookup, drain assembly, and seal testing. We shut off the angle stops, disconnect the old supply lines, clean the deck or sink surface, and check the mounting holes against the new faucet footprint. On a standard bathroom sink that means a pipe wrench, a basin wrench for the back nuts, and a caulking gun for a clean silicone bead. Then we pressurize the line and watch for weeps at every joint.
Most Scottsdale homeowners call us because hard water has chewed through the cartridge or the finish is pitted past cleaning. Our water runs heavy with calcium, so a faucet that is five years old here often behaves like a ten-year-old fixture elsewhere. If you have been searching for faucet replacement near me Scottsdale AZ, we can usually get eyes on it the same day. We also swap kitchen and bath fixtures during larger remodels, so the plumbing and the tile work line up.
- ✓ Stop the Drip for Good
- ✓ Hard Water Handled Right
- ✓ Same-Day Turnaround
- ✓ Clean, Code-Correct Work
What's included
What Our Faucet Installation Service Includes
Every standard faucet install covers the full swap from shutoff to pressure test. If we find a problem behind the wall or under the sink, we tell you the price before we fix it, so there are no surprises on the invoice.
New Supply Lines
Braided stainless supply lines go on with fresh washers. We check the shutoff valves for corrosion and replace a seized valve on the spot if it will not hold. That is the number one cause of a callback.
Drain and Pop-Up Assembly
The drain flange, gasket, and pop-up rod get set and adjusted so the stopper seals and opens smoothly. We test with a full basin of water to confirm no weep at the tailpiece.
Silicone Seal at the Base
A clean silicone caulk line around the faucet base keeps water from wicking under the fixture and into the cabinet. We use mold-resistant silicone and tool the bead smooth.
Pressure Test and Cleanup
Hot and cold run for two minutes while we watch every joint. Drop cloths come up, the sink gets wiped, and you get a walkthrough of the shutoffs and warranty terms.
How it works
How Our Faucet Installation Process Works
You call or book online with the fixture type, sink style, and a photo if you have one. We confirm whether it is a bathroom faucet installation Scottsdale job or a kitchen swap, check parts availability, and give you a flat price range before we roll.
We kill the angle stops, open the faucet to bleed pressure, and disconnect the supply lines. The old fixture comes out with a basin wrench and a screw gun for stubborn brackets. We inspect the deck for corrosion and the cabinet for old water damage.
The mounting surface gets cleaned and dried. We check hole spacing against the new faucet base, set the gasket or silicone bead, and feed the supply lines through. A laser level confirms the spout sits square to the sink edge.
New braided supply lines go on with fresh washers, hand-tight plus a quarter turn. We connect the drain assembly, set the pop-up rod, and run a silicone caulk line around the base. PEX or copper stub-outs get checked for pitting before we reconnect.
We open the stops, run hot and cold for two minutes, and wipe every joint with a dry rag to catch weeps. You get a walkthrough of the shutoff valves, the warranty terms, and a reminder to check the caulk line each spring.
STEP 01Call and Scope
You call or book online with the fixture type, sink style, and a photo if you have one. We confirm whether it is a bathroom faucet installation Scottsdale job or a kitchen swap, check parts availability, and give you a flat price range before we roll.
Tools & methods
Tools and Methods We Use
Basin wrench
Reaches the back mounting nuts under a sink where a standard wrench will not fit. Essential for tight vanity cabinets.
Pipe wrench
Breaks loose corroded supply connections and holds the shutoff valve body while we disconnect the line.
Caulking gun
Lays a clean, even silicone bead around the faucet base and backsplash seam. We use mold-resistant silicone.
Laser level
Confirms the faucet spout sits square to the sink edge, especially on wide-set or double-handle fixtures.
Oscillating multi-tool
Cuts stubborn caulk lines and trims a stuck gasket without gouging the countertop or sink deck.
Moisture meter
Checks the cabinet floor and framing for hidden water damage after a long-running leak before we close up.
Real results
Before and after.
Faucet Installation
Kitchen Faucet Swap in 85258
A 12-year-old builder-grade kitchen faucet with a dripping spout and a stiff handle. The base had a failed caulk line and water was staining the cabinet floor. The shutoff valve under the sink was seized open.
After: We replaced the faucet with a Moen pull-down, swapped the seized shutoff for a quarter-turn ball valve, and re-sealed the base. Total time was two hours. The cabinet floor dried out and the drip stopped completely.
Book this service → Faucet Installation
Dual Bath Faucets in a 1980s Home
Both bathroom faucets were original, with pitted chrome and cartridges that had seized from mineral scale. The handles needed two hands to turn and one faucet dripped constantly.
After: We installed two Delta wide-set faucets with ceramic cartridges, new supply lines, and fresh silicone at both bases. The job took about three hours. Both handles now turn with one finger and there are no drips.
Book this service →
Faucet Installation
Touchless Faucet Upgrade in Fountain Hills
A powder room faucet with a failed touch sensor and a corroded battery pack. The outlet nearby was not GFCI-protected, and the faucet would run intermittently on its own.
After: We removed the old fixture, installed a hardwired touchless faucet, and ran a GFCI-protected circuit to the vanity. The sensor now works every time and there are no batteries to change. Total job was about four hours including the electrical.
Book this service → Problems we solve
Faucet Problems We Fix in Scottsdale
Hard water, age, and cheap builder-grade parts cause most of the faucet calls we run. Here are the ones we see most often and what happens if you let them ride.
Ask a pro →Faucet drips after you shut it off
We pull the cartridge, check the seats and O-rings, and either rebuild the valve or replace the faucet. Most drips stop the same visit. If the body is pitted, a new fixture is the cheaper long-term call.
Handle is stiff or will not move
We open the valve, clear the mineral scale from the cartridge, and lubricate with plumber's grease. If the cartridge is scored, we swap it for a ceramic replacement built for hard water.
Water pools at the faucet base
We pull the faucet, dry the deck, replace the gasket or packing, and re-seal with silicone caulk. If the cabinet shows water damage, we flag it and can repair the panel.
Low water pressure at the faucet only
We remove and clean the aerator, flush the supply lines, and check the cartridge for scale. If the shutoff valve is the restriction, we replace it and restore full flow.
Proof you can check
Licensed, Insured, and Reviewed
- Arizona ROC (Registrar of Contractors) License · Arizona Registrar of Contractors
- EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
- ANSI A118 Tile Installation Standards · American National Standards Institute
- TCNA Guidelines Compliance · Tile Council of North America
- OSHA Safety Compliance · Occupational Safety and Health Administration
Most standard faucet swaps in Scottsdale run $180 to $450 in 2026, including labor, new supply lines, and sealant. A basic bathroom faucet sits at the low end; a kitchen faucet with a pull-down sprayer or a touchless faucet installation Scottsdale AZ job runs higher. If the shutoff valves are seized or the drain assembly needs replacing, expect another $60 to $150.
Look for a faucet with a ceramic disc cartridge and a solid brass body, like the Moen or Delta mid-tier lines. Ceramic discs resist calcium scoring far better than rubber seats. A brushed nickel or matte finish hides hard water spots better than polished chrome. If you want maximum life, add an inline filter under the sink to cut mineral content before it reaches the valve.
A standard bathroom faucet replacement takes 60 to 90 minutes on site. A kitchen faucet with a sprayer and a soap dispenser usually runs 90 minutes to two hours. If we hit corroded shutoff valves or a stripped mounting nut, add 30 to 45 minutes. We block two hours for most jobs so there is no rush at the end.
You can, but the two failure points are the supply line connections and the drain seal. Over-tightening a compression nut cracks the valve body; under-tightening weeps into the cabinet. If you are on a slab with no shutoff access, one wrong move means a main-line shutoff. Most homeowners call us after the second trip to the hardware store.
Ready when you are
Book Faucet Installation Scottsdale AZ Today
One call gets you a flat price, a licensed installer, and a faucet that shuts off clean. We carry common fixtures on the truck and can often finish the same day you call. If water is running where it should not, we answer 24/7.
Get a Flat Quote +18556124434 →
Request an appointment
Contact Our Scottsdale Bathroom Team
Call +1 855-612-4434 or email [email protected] and we will get back to you the same business day. We answer the phone Monday through Friday, 8:00 to 18:00, and we schedule walkthroughs across Scottsdale and Maricopa County within a few days. Bring your wish list and your budget.